For instance, if your system had 8 cameras attached, but you wanted to view the cameras in a
4-camera format, you could use the matrix to define that box 1 would show camera 3, box 2
would show camera 5, box 3 would cycle through cameras 1, 2 and 4 and that box 4 would
cycle through cameras 6,7 and 8. You would also define the number of seconds that the
camera is to be displayed before switching to the next camera.
The default for each box of the matrix is that camera 1 will be shown permanently in box 1,
camera 2 in box 2 and so on. The picture below shows camera 1 set to show permanently in
box 1:
The picture below shows box 4 of the display configuration defined to sequentially switch
through cameras 4, 5 and 6 with varying display times.
